Wagner PEM T3 Manual

Inside This Document

Operating manual for the Wagner PEM-T3 tribo manual spray gun (article no. 0351019) — a powder gun that charges powder by friction (tribo charging) rather than corona electrodes, suited to faraday-cage geometries and certain powder chemistries. The 28 pages identify the gun's components (deflector cone, nozzle body, outer nut, trigger, air and powder supplies), cover high-voltage safety and safe operation, and document setup and service parts for running tribo powder application.

From the Document

03/2008 0351709 http://www.wagner-group.com Operating Manual Tribo Manual Spray Gun DANGER High Voltage! Turn power off before servicing! CAUTION Read rules for safe operation and instructions carefully! pemt3_0000 0351967 PEM-T3 C E R T I F I E D D I N I S O 9 0 0 1 Introduction 2 0351709 - PEM-T3 03/2008 Tribo manual spray gun Article No. 0351019 00_Pemt3_Aufbau.doc A B D H C E G F pemt3_0001 A Deflector cone B Nozzle body C Outer nut D Spray gun body E Trigger F Tribo air connection G Powder hose connection H Power supply The Tribo manual spray gun PEM-T3 is used for powders suitable for friction loading. The PEM-T3 powder spray gun is used for industrial powder coating. This spray gun can be operated with the following control units: • EPG 2008 with powder injector PI-P1 • EPG-D1 with powder injector PI-F1 • Control unit Bravo with powder injector PI-FM1 The powder feed and the Tribo air supply to the spray gun are activated by pressing the trigger. Caution The user must ensure, that the spray gun is only connected to Wagner equipment! High ambient temperatures must be avoided; in particular, the hoses must not be routed through factory areas exposed to direct sunlight! To provide a safeguard against unintentional use of the spray gun, the control unit must be turned off! Introduction 03/2008 0351709 - PEM-T3 3 Table of contents Page 1. Safety regulations 5 1.1 Safety hints 5 1.2 EC Declaration of conformity 6 2. Preparing the spray gun 7 2.1 Select the suitable nozzle system 7 2.2 Connecting the spray gun 7 2.3 Grounding 8 3. Working with the spray guns 9 3.1 Start up…