Binks SV50

Inside This Document

Part sheet 77-2891R for the Binks SV50 HVLP gravity feed spray gun and its touch-up companion. HVLP air supply requirements lead the document: the full-size gun needs 30 PSI inlet pressure to deliver the compliant 10 PSI at the air cap while consuming 12 CFM (8 CFM for the touch-up), on 5/16" or larger I.D. air hose. Specifications across the 8 pages include 100 psi maximum air pressure, cast aluminum body, aluminum fluid path, stainless steel nozzle and needle, and 1/4" NPS(M) air inlet, with operation, maintenance, and parts.

From the Document

Binks SV50 HVLP Gra V ity Feed S P ray Gun & t ouc H u P Gun Replaces Part Sheet 77-2891 Part Sheet 77-2891R ATTENTION! READ BEFORE ATTACHING THE AIR HOSE HVLP AIR SUPPLY REQUIREMENTS FULL SIZE GUN: 30 PSI inlet pressure provides 10 PSI at the air cap. Consumes 12 CFM. TOUCHUP GUN: 30 PSI inlet pressure provides 10 PSI at the air cap. Consumes 8 CFM. NOTE: USE 5/16" OR LARGER I.D. AIR HOSES SPECIFICATIONS Max. Air Pressure: 100psi For HVLP Compliance: 30 psi inlet pressure delivers 10 psi air cap pressure Gun Body: Cast Aluminum Fluid Path: Aluminum Fluid Nozzle: Stainless Steel Fluid Needle: Stainless Steel Air Inlet Size: 1/4" NPS(M) OPERATION AN d M AINTENANCE INSTR u CTIONS Your new SV50 Gravity Feed Spray Gun and Gravity Feed Touchup Gun are exceptionally rugged in construction and built to stand up under hard, continuous use. However, like any other fine precision instruments, their most efficient operation depends on a knowledge of their construction, operation, and maintenance. Properly handled and cared for, they will produce beautiful, uniform finishing results long after other spray guns have worn out. S ET - uP FOR S PRA y IN g (Figure 1) C ONNECTIN g g u N TO A IR H OSE Air should be supplied by a suitable length of 5/16" diameter air hose fitted with a 1/4 NPS(f) connection to the base of the gun handle. For hose lengths over 50', use 3/8" hose. C ONNECTIN g gRA v IT y F EE d Cu P TO g u N Screw the cup into the spray gun fluid inlet. Fill the cup with filtered paint. If desired, attach air adjusting valve with gauge and/or quick disconnect to air inlet, then…