Binks 75M

Inside This Document

Operating and service manual for the Binks 75M, an air-assisted airless spray gun — 24 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

77-3084-R2.0 (1/2015) 4 / 12 EN BINKS AIRLESS 75M SPRAY GUN KEEP CLEAR OF NOZZLE: Do not exceed maximum working pressure of 7500 PSI (517 BAR, 51.7 Mpa). ! CAUTION PREVENTION: NEVER Aim the gun at any part of the body. NEVER Allow any part of the body to touch the fluid stream. DO NOT allow body to touch a leak in the fluid hose. NEVER Put hand in front of the gun. Gloves will not provide protection against an injection injury. ALWAYS lock the gun trigger, shut the pump off, and release all pressure before servicing, cleaning the tip or guard, changing the tip, or leaving unattended. Pressure will not be released by turning off the motor. The PRIME/SPRAY valve must be turned to PRIME to relieve the pressure. Refer to the PRESSURE RELIEF PROCEDURE described in the pump manual. ALWAYS Keep the tip guard in place while spraying. The tip guard provides some protection, but is mainly a warning device. ALWAYS Remove the spray tip before flushing or cleaning the system. ALWAYS inspect the hose before each use. The paint hose can develop leaks from wear, kinking, and abuse. A leak can inject material into the skin. NEVER Use a spray gun without a trigger lock and trigger guard in place and in good working order. All accessories must be rated at 7500 PSI (517 BAR) or higher. This includes