Binks Model 7

Inside This Document

Service manual 77-1153 for the Binks Model 7 spray gun (6100-XXXX-X) — one of the longest-running guns in the industry, exceptionally rugged and built for hard, continuous use. The 12 pages cover the installation types starting with siphon feed cup hookup and air pressure setup, then construction, operation, and maintenance knowledge that keeps a Model 7 producing uniform finishes, with the complete service parts list and repair references for a gun that routinely outlasts its replacements.

From the Document

EN 77-1153-R25.3 (5/2016) 1 / 12 SERVICE MANUAL BINKS MODEL 7™ SPRAY GUN (6100-XXXX-X) Your new Binks spray gun is exceptionally rugged in construction, and is built to stand up under hard, continuous use. However, like any other fine precision instrument, its most efficient operation depends on a knowl edge of its construction, operation, and maintenance. Properly handled and cared for, it will produce beautiful, uniform finishing results long after other spray guns have worn out. TYPES OF INSTALLATION SIPHON FEED CUP HOOKUP Air pressure for atomization is regulated at extractor. The amount of fluid is adjusted by fluid control screw on gun, viscosity of paint, and air pressure (see figure 1). Clean Air™ filter Figure 1 Air Siphon Cup Clean Air™ filter Cup Regulator Figure 2 Air Fluid Pressure Cup Clean Air™ filter Figure 5 Air Fluid Fluid Regulator Fluid Figure 4 Air Supply Air Supply Pressure Tank Clean Air™ filter Air Inlet Figure 3 Air Pressure Tank Fluid PRESSURE FEED TANK HOOKUP For portable painting operations (double regulator). Air pressure for atomization and fluid supply is regulated by two individual air regulators on tank (see figure 4). PRESSURE FEED CIRCULATING HOOKUP For heavy production spraying. Air pressure atomization regulated at extractor. Fluid pressure regulated at fluid regulator (see figure 5). PRESSURE FEED TANK HOOKUP For medium production spraying (sin gle regulator). Air pressure for atomi zation is regulated at extractor, fluid pressure at tank regulator (see figure 3). PRESSURE FEED CUP HOOKUP For fine finishing with limited spraying. Air…