C.A. Technologies Lynx 100H

Inside This Document

The setup and parts sheet for the C.A. Technologies Lynx 100H — the compliant HVLP Lynx. The chart maps the 21-1090/21-1091/21-1092 caps at 15 PSI maximum gun inlet pressure and 6–8 SCFM to fluid nozzles from 0.5 mm (31-0205) upward with matching needles and CAT Pack contents flagged. The 5-page reference for low-CFM compliant setup on CAT's mid-line gun.

From the Document

HVLP AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS PRESS. OR SIPHON *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET AIR CAP RING STANDARD IN CAT PACK AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 21-1090 pressure 15 6 31-0205 0.5mm (.020") 21-1091 pressure 15 8 Included 31-0208 0.8mm (.022") 21-1092 pressure 15 8 31-0210 1.0mm (.040") 21-1093 pressure 18 10 31-0212 1.2mm (.046") 21-1094 pressure 33 13 Included 31-0213 1.3mm (.052") 21-1095 pressure 50 22.5 31-0214 1.4mm (.055") 21-1097 pressure 50 22.5 31-0215 1.5mm (.059") 21-1195 pressure 50 22.5 31-0216 1.6mm (.063") 21-1197 pressure 50 22.5 Included 31-0217 1.7mm (.070") 31-0412 1.2Fmm (.046") 40-1112F (112F) 31-0414 1.4Fmm (.055") 40-1114F (114F) 31-0417 1.7Fmm (.070") 40-1117F (117F) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Note: Air cap test gages are available to confirm HVLP compliance. *Gun inlet pressures may vary as required by application 40-1100 (100) LYNX 100H (L100H) 21-1001 Included 60-1502 (#2) Lynx 100H PRESSURE FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for L100H Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can be controlled using the fluid control knob, this restricts flow by limiting needle travel. It is best to control fluid flow by proper selection of fluid orifice size and use the fluid…