C.A. Technologies CPR-G

Inside This Document

The setup and parts sheet for the C.A. Technologies CPR-G gravity feed spray gun. The HVLP/pressure-reduced chart maps fluid tips from 0.8 mm (33-0208) through 1.2 mm and beyond with matching 40-13xx needles, maximum gun inlet pressures for compliance, and SCFM figures, with W and W-PPS cup variants flagged for 3M PPS users. The 4 pages cover setup combinations and reorder part numbers for the gravity CPR.

From the Document

HVLP/PRESSURE REDUCED AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS FLUID TIP RANGE *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET STANDARD IN CAT PACK AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle 33-0208 0.8mm (.022") 40-1308 (308) W, W-PPS 33-0210 1.0mm (.040") 40-1310 (310) 33-0212 1.2mm (.046") 40-1312 (312) W, A, PPS 33-0213 1.3mm (.052") 40-1313 (313) 33-0214 1.4mm (.055") 40-1314 (314) W, A, PPS 33-0215 1.5mm (.059") 40-1315 (315) W, A, PPS 33-0217 1.7mm (.070") 40-1317 (317) 33-0219 1.9mm (.075") 40-1319 (319) 33-0222 2.2mm (.086") 40-1322 (322) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Note: Air cap test gages are available to confirm HVLP compliance. *Gun inlet pressures may vary as required by application CPR-G 60-1504 (S) 23-2101 CPR (Pressure Reduced) 23-1301 (HVLP) 0.8 - 1.7 0.8 - 2.2 29* 29* 11 13.5 CPR-G GRAVITY FEED SPRAY GUN PRODUCT INFORMATION The CPR-Gravity gun comes equipped with both a pressure reduced air cap 23-2101 and a HVLP air cap 23-1301 for areas requiring HVLP compliance. 23-2101 - consumes 11 cfm at 29 psi gun inlet. 23-1301 - consumes 13.5 cfm at 29 psi gun inlet. 23-2101 pressure reduced air caps can be used with the 0.8 mm - 1.7 mm fluid orifices listed below. 23-1301 HVLP air caps can be used with the full range of fluid orifices listed below. DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for CPR-G Spray Guns Operation 1. Connect air supply hose at handle of…