C.A. Technologies CPR-FE

Inside This Document

The setup and parts sheet for the C.A. Technologies CPR-FE spray gun — the fine-finish edition of the CPR platform. The HVLP/pressure-reduced air cap and fluid nozzle chart maps fluid tips from 0.8 mm (33-0208) with matching 40-18xx needles, maximum gun inlet pressures for compliance, SCFM consumption, and standard CAT Pack contents. The 4 pages answer cap/tip/needle selection for fine-finish compliant spraying.

From the Document

HVLP/PRESSURE REDUCED AIR CAP AND FLUID NOZZLE CHART MODEL NO. AIR CAPS FLUID TIP RANGE *MAX GUN INLET PRESS. FOR HVLP FAN CONTROL SCFM @ MAX GUN INLET STANDARD IN CAT PACK AVAILABLE FLUID NOZZLES TIPS NEEDLES / marking on needle Included 33-0208 0.8mm (.022") 40-1808 (08) 33-0210 1.0mm (.040") 40-1810 (1810) 33-0212 1.2mm (.046") 40-1812 (1812) Included 33-0213 1.3mm (.052") 40-1813 (1813) 33-0214 1.4mm (.055") 40-1814 (1814) 33-0215 1.5mm (.059") 40-1815 (1815) Included 33-0217 1.7mm (.070") 40-1817 (1817) Actual fluid nozzle and air cap combinations are determined by application (see application chart page 4) *Note: Air cap test gages are available to confirm HVLP compliance. *Gun inlet pressures may vary as required by application 60-1317 11 13.5 23-2101 CPR (Pressure Reduced) 0.8 - 1.7 29* CPR-FE 23-1301 (HVLP) 0.8 - 17 29* The CPR-FE gun comes equipped with both a pressure reduced air cap 23-2101 and a HVLP air cap 23-1301 for areas requiring HVLP compliance. 23-2101 - consumes 11 cfm at 29 psi gun inlet. 23-1301 - consumes 13.5 cfm at 29 psi gun inlet. 23-2101 pressure reduced air caps can be used with the 0.8 mm - 1.7 mm fluid orifices listed below. 23-1301 HVLP air caps can be used with the full range of fluid orifices listed below. CPR -FE PRESSURE FEED SPRAY GUN PRODUCT INFORMATION DISTRIBUTED BY COATING EQUIPMENT TECHNOLOGY, INC PHONE: 586-210-0555 WEB: www.cetinc.com Operation and Maintenance Instructions for CPR-FE Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply to the gun fluid inlet. 3. Fluid flow can…