Binks Trophy Lvmp

Inside This Document

Operating and service manual for the Binks Trophy Lvmp, a spray gun — 80 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN 77-3026-R2.0 (9/2014) 4 / 16 BINKS “TROPHY” SERIES SPRAY GUN PRESSURE AND SIPHON GUN ORIFICE SIZES 50 0.50 MM 85 0.85 MM 10 1.0 MM 12 1.2 MM 14 1.4 MM 16 1.6 MM 18 1.8 MM 20 2.0 MM 22 2.2 MM 24 2.4 MM 26 2.6 MM CUP DESIGNATION 0 NO CUP S SIPHON CUP 2465 – XXXX – XXXX NEEDLE MATERIAL S STAINLESS (HARDENED) V VITREOUS (TUNGSTEN CARBIDE NEEDLE & NOZZLE) P PLASTIC TIP AIR CAP DESIGNATION 10 Series CONVENTIONAL 20 Series LVMP 30 Series HVLP ATOMIZATION TECHNOLOGY CN CONVENTIONAL LV LVMP HV HVLP NUMBERING SYSTEM FOR FULL SIZE BINKS “TROPHY” SERIES SPRAY GUNS Side port adjusting valve can be used as an optional air adjusting valve. See charts on page 6 for complete gun assemblies. ! CAUTION The fluid inlet is not meant to be removed or replaced. EN 77-3026-R2.0 (9/2014) 5 / 16 ITEM NO. PART NUMBER DESCRIPTION QTY. 1 54-6120 AIR CAP RETAINING RING ASSEMBLY 1 5 SEE CHARTS ON PAGE 7 AIR CAP 1 6 JGA-156-K10 SPRING-CLIP (KIT OF 10) 1 7 SEE CHARTS BELOW FLUID NOZZLE 1 8 54-6102-K3 BAFFLE/SEPARATOR (KIT OF 3) 1 9 54-6122 SIDE PORT VALVE ASSEMBLY 1 10 ------ + 6 RETAINING CLIP 1 11 ------ + BODY BUSHING 1 12 ------ + 6 O-RING 1 13 ------ + SIDE PORT STEM 1 14 ------ + 6 PIN 1 15 54-6131-K ❏ AIR VALVE SERVICE KIT 1 16 ------ • FRONT SEAL – AIR VALVE 1 17 ------ • FRONT AIR VALVE SEAL 1 18 54-