Binks Model 30

Inside This Document

Part sheet 77-2151 for the Binks Model 30 glass bead dispensing gun (6279-0000 series) — delivering glass beads at up to 20 lbs/min for reflective marking applications. No atomization air is required; on-off is handled by the air cylinder at the rear of the gun body, with a 50 PSIG minimum cylinder pressure and a pressure tank with follower plate and bottom outlet recommended for bead supply. The 4 pages cover setup, operation, and service parts (54-380 and related components).

From the Document

The Model 30 Glass Bead Dispensing Gun delivers glass beads at the rate of up to 20 lbs. per minute. (A pressure tank with follower plate and bottom outlet is recommended for supply of glass beads to the gun.) Air for atomization is not required. “On-off” of the gun is provided by the air cylinder. It is located at the rear of the gun body. The minimum recommended air pressure to the cylinder is 50 PSIG. ! CAUTION The gun should never be operated without having the guard (28) installed. All threads, including the hose connections, should be clean of beads before mating. The needle (15) should always be kept clean. INSTALLATION Mount the Model 30 gun on a 1/2” diameter steel rod. (Not furnished with gun. Please order separately, Model 54-380.) The rod should have a flat area to receive the mounting screw (19) for locking the gun to the rod. Attach the air hose to the 1/4" NPS(m) nipple (21) and attach the glass bead supply hose to the 3/4" NPS(m) inlet on the gun head (16). NOTE Be sure mating threads are clean of beads. Depending on the delivery required, select the appropriate nozzle (orifice) insert (13) and install into the deflection nozzle (12). Install this assembly (14) into the gun and fasten securely with retainer ring (10) and o-ring (11). NOTE Be sure mating threads are clean of beads. DISASSEMBLY INSTRUCTIONS Read entire disassembly instructions before attempting repairs. Do only that which is required to repair a specific trouble. Complete disassembly may not be required. 1. Remove the screw (27) and guard (28). 2. Remove cap (3), control screw (1) and…