Binks Mach 1A/1AV

Inside This Document

Part sheet 77-2467 for the Binks MACH 1A and 1AV HVLP automatic spray guns (6203-XXXX-X / 5203-XXXX-X) — the automatic version of the MACH 1 platform, built rugged for hard, continuous production use. The 12 pages cover construction, operation, and maintenance knowledge for machine-mounted HVLP spraying, including setup, air supply requirements, and the complete service parts breakdown for keeping automatic MACH guns producing uniform finishes on production lines.

From the Document

Your new Binks MACH 1A HVLP Automatic Spray Gun is exceptionally rugged in construction, and is built to stand up under hard, continuous use. However, like any other fine precision instrument, its most efficient opera - tion depends on a knowledge of its construction, opera - tion and maintenance. Properly handled and cared for, it will produce beautiful, uniform finishing results long after other spray guns have worn out. The automatic MACH 1A HVLP gun is a conventional style airspray gun with special nozzles and modifications that allow it to operate at high transfer efficiencies in compliance with the “California South Coast Air Quality Management District” regulations as a “high volume, low pressure” airspray gun. High pressure, low volume airflow is converted to high volume, low pressure within the gun body. Special air and fluid nozzles enable the gun to atomize fluid at low air pressures and velocities, creating the “soft spray” effect for high transfer efficiencies. CAUTION Before removing any components from spray gun, shut off air and material pressure. ! NOTE IMPORTANT REGULATORY NOTE regarding the use of this product appears on page 10. MACH 1A HVLP (MACH 1AV HVLP) AUTOMATIC AIRSPRAY GUN 6203-XXXX-X MACH 1A 5203-XXXX-X MACH 1AV 77-2467-R17 (3/2018) 1 / 12 www.carlisleft.com EN SERVICE MANUAL LOCK OUT / TAG-OUT Failure to de-energize, disconnect, lock out and tag-out all power sources before performing equipment maintenance could cause serious injury or death. OPERATOR TRAINING All personnel must be trained before operating finishing equipment. EQUIPMENT MISUSE…