Binks Mach 1PCX

Inside This Document

Service manual 77-2687 for the Binks MACH 1PCX HVLP spray gun, built for plural component catalyst injection — applying catalyzed materials where the catalyst is injected at the gun rather than pre-mixed. The 12 pages lead with the safety disciplines this class of equipment demands (lock-out/tag-out before maintenance, operator training requirements) and continue through setup, operation, and the service parts list for keeping a catalyst-injection HVLP system running safely in composites and high-solids production.

From the Document

EN 77-2687-R3.2 (8/2016) 1 / 12 SERVICE MANUAL Binks M ACH 1 PCX HVLP SPRAY GUN (For Plural Component Catalyst Injection) EN 77-2687-R3.2 (8/2016) 2 / 12 Binks reserves the right to modify equipment specification without prior notice. LOCK OUT / TAG-OUT Failure to de-energize, disconnect, lock out and tag-out all power sources before performing equipment maintenance could cause serious injury or death. OPERATOR TRAINING All personnel must be trained before operating finishing equipment. EQUIPMENT MISUSE HAZARD Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result in serious injury. PROJECTILE HAZARD You may be injured by venting liquids or gases that are released under pressure, or flying debris. PINCH POINT HAZARD Moving parts can crush and cut. Pinch points are basically any areas where there are moving parts. INSPECT THE EQUIPMENT DAILY Inspect the equipment for worn or broken parts on a daily basis. Do not operate the equipment if you are uncertain about its condition. In this part sheet, the words WARNING , CAUTION and NOTE are used to emphasize important safety information as follows: Hazards or unsafe practices which could result in minor personal injury, product or property damage. ! CAUTION Hazards or unsafe practices which could result in severe personal injury, death or substantial property damage. ! WARNING Important installation, operation or maintenance information. NOTE Read the following warnings before using this equipment. READ THE MANUAL Before operating finishing equipment, read and understand all safety,…