Sagola 610 Pressure Tank Manual

Inside This Document

Operating manual for the Sagola 610 pressure feed tank. Covers safe start-up and depressurization, loading material, connecting air and material hoses, regulating pressure, and maintenance of the lid, gaskets, and fittings.

From the Document

START UP Make sure there is no pressured air remained in the tank before using. If there is, release it with turning release cock counterclockwise until pressure bleeds down. Connect the air supply hose to the air inlet, which is fitted above pressure regulator. It is better for the air supply hose to pass through a transformer to filter dirt from air and remove entrained water and oil. Connect the atomization air hose to the air outlet. Connect material hose to the fluid outlet. Turn on the air supply, turn pressure regulator clockwise to gain working pressure. Atomization air for the spray gun can be adjusted at the gun by means of an air adjusting valve or adding and air regulator kit to the tank. Operate spray gun according to the instructions attached with it. Loose air cap retaining ring on spray gun about three turns. Cup cloth over air cap on the gun and pull trigger. Then, clean all the parts which are on contact with the product with a suitable solvent. Replace the lid and tighten all the thumb nuts. Repeat steps 1 - 4 in order to force the solvent back to the tank. For all