DeVilbiss Compact Conventional Pressure Feed

Inside This Document

Operating and service manual for the DeVilbiss Compact Conventional Pressure Feed, a spray gun — 20 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

SB-2-548-M (10/2017) 4 / 10 EN www.carlisleft.com INSTALLATION Important: To ensure that this equipment reaches you in first class condition, protective coatings have been used. Flush the equipment through with a suitable solvent before use. 1. Attach air hose to connector (13). Recommended hose size 5/16" ID. 2. Attach fluid supply hose to Fluid Inlet (15). OPERATION 1. Mix coating material to manufac - turers instructions 2. Turn needle adjusting screw (7) clockwise to prevent movement. 3. Turn spreader valve (5) counter- clockwise to fully open. 4. Adjust inlet air pressure (For recom - mended figures see Specifications) at the gun inlet with the gun trig - gered. (pressure gauge attachment shown under Accessories is recom - mended for this). 5. Turn needle adjusting screw counter clockwise until first thread shows or full needle travel is achieved. 6. Test spray. If the finish is too dry reduce airflow by reducing air inlet pressure or by the Airflow Valve (14). Screw the Adjusting Knob (14) in to reduce pressure. 7. If finish is too wet reduce fluid flow by turning needle screw (7) clock - wise or reducing the fluid pressure. If atomization is too coarse, increase inlet air pressure. If too fine reduce inlet pressure. 8. The pattern size can be reduced by turning spreader va