Binks GEMS Air Cut Off Kit

Inside This Document

Reference guide for the Binks GEMS Air Cut Off Kit — air cap, nozzle, and setup selection data to match the right configuration to the application. Distributed by CET.

From the Document

Connect ACO valve signal line here EN 77-3087-R1.0 (8/2015) 4 / 5 Connect the ACO swivel fitting to the outlet of the air flow switch (upper fitting). Orient valve so the tube elbow is on top and points toward the rear of the enclosure. For systems without Flush Boxes: Connect one end of the supplied tubing into the port on the back side of the enclosure as shown in the picture at left. The corresponding bulkhead should connect to the ACO solenoid inside the cabinet. For systems with Flush Boxes: Connect the tubing supplied with the gun flush box to the ACO port on the Flush Box and the elbow fitting on the ACO valve. See flush box instructions for additional detail. If installing ACO for two guns (and no gun flush boxes), a “Y-adapter” included in the 2-gun version of the kit is required to split the air cut off signal to both valves. Install it on the appropriate bulkhead, and connect both tubes to the connector and ACO valves. Attach atomizing air supply hose to inlet (bottom) of air flow switch. Attach gun air hose to outlet of ACO valve. Using the valve: the system software (or gun flush box) will shut off atomizing air for priming, flushing, and color loading operations. After color is loaded and the system is ready to spray the atomizing air will be enabled after the “gun