Binks 135-80 Pulse Chamber & Filter

Inside This Document

Service sheet for the Binks 135-80 Pulse Chamber & Filter, a fluid filter/strainer — 2 pages covering setup, parts, and correct use. Distributed by CET.

From the Document

EN 77-2559-R2.3 ( 5/2016) 1 / 2 SERVICE MANUAL MODEL 135-80 PULSE CHAMBER & FILTER ITEM PART NO. NO. DESCRIPTION QTY. 1 — SUMP BODY ..................................... 1 2 — FILTER HEAD ..................................... 1 3 135-78 FILTER ELEMENT (40 MESH) .............. 1 4 135-79 SEAL (EPT COMPOUND, RED) .............. 1 Accessories, sold separately: 135-77 Filter Element (80 mesh) 135-136 Seal (Fluorocarbon Rubber, Green) PARTS LIST When ordering, please specify Part No. 1 3 4 2 Note direction of flow arrow. 3 9 16 " 90mm 5 3 32 " 129mm 3/8" NPT Both ends Direction of flow SPECIFICATIONS Maximum fluid pressure: 150psi [10 bar] Materials of construction: Polypropylene, Stainless Steel, EPT Top installation provides an air cushion and acts as a pulse chamber. Bottom installation is more common and requires less clean up when servicing the element. A 5-inch clearance is required for removal of the sump body. NOTE Prior to 2013 the filter body was nylon (white in color.) EN 77-2559-R2.3 ( 5/2016) 2 / 2 Carlisle Fluid Technologies reserves the right to modify equipment specifications without prior notice. DeVilbiss ® , Ransburg ® , MS ® , BGK ® , and Binks ® are registered trademarks of Carlisle Fluid Technologies, Inc. ©2016 Carlisle Fluid Technologies, Inc. All rights reserv