Binks 31-133-CE Agitated Lid Assembly

Inside This Document

Operating and service manual for the Binks 31-133-CE Agitated Lid Assembly, a paint agitator / air-motor drive — 40 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN 77-2877-R4.1 (12/2015) 4 / 8 INSTALLATION Air Supply Air supplies (compressors, etc.) shall be sited in a non-hazardous area with a filter on the air intake system to prevent the ingress of dust or similar foreign material into the parts where compression takes place. ! WARNING AIR MOTOR LUBRICATION An automatic air line filter/ lubricator should be installed in the air supply line no more than 0.5m (19 in) from the air motor. The filter should be 5 micron. Install the lubricator level with or above the motor so the oil mist will blow directly into or down into the motor (see Fig. 1). ! WARNING Fill the oil reservoir with SAE 10W motor oil. Adjust lubricator to feed 1 drop of oil for every 1400 litres (50 cfm) of air or 1 drop per minute for continuous running. KIT ASSEMBLY Only Use the proper Lid assembly 41-3205 with this Agitator. 1. Remove the propeller (10) from the shaft (3) by loosening the lock screw (9). 2. Unscrew the locknut (5) from the housing, and remove washer (8). 3. Insert the shaft into the aperture in the lid and rotate until the pin locates in the slot. 4. Slide the washer (8) over the shaft, the raised centre towards the locknut. 5. Replace the locknut (5) and tighten. 6. Replace the propeller (10) and secure with screw (9). 7. Place the lid assembly over