Binks QMS-436 Double Regulator Kit

Inside This Document

Service sheet for the Binks QMS-436 Double Regulator Kit, an air/fluid pressure regulator — 2 pages covering setup, parts, and correct use. Distributed by CET.

From the Document

Figure 1 QMS-436 Double Regulation Conversion Kit Figure 2 Typical Single Regulation PURPOSE For use where independent and accurate pressure control of both air and fluid is essential. Used with portable air compressors or with air lines when no other means (air transformers or regulators) of air pressure regulation is available. INSTALLATION To avoid blast of air when installing regulator on tank or pump, always turn off air supply and bleed off air in the tank by turning the air relief valve thumb screw counterclockwise. Wait until all the air has escaped before removing regulator. Note Use pipe sealant on all pipe thread connections. 1. Before removing regulators on tanks with air motors, disconnect the air supply hose from the air motor. Remove fluid pressure regulator at swivel adapter. Refer to Figure 2. 2. Remove air outlet valve. 3. Install hex nipple (1, Figure 1) in right side of fluid pressure regulator. 4. Install air pressure regulator (2) with gauge (3) on D.M. nipple 1/4 x 3/8 universal pipe thread (1). Do not turn gauge case by hand or with a tool. Use the stem underneath the gauge case. 5. Install outlet valve in right side of air pressure reg- ulator (2). 6. Close unused ports with the pipe plug supplied with regulator. 7. Align assembly on tank air manifold and