Binks HAR-508 Air Regulator

Inside This Document

Service sheet for the Binks HAR-508 Air Regulator, an air/fluid pressure regulator — 2 pages covering setup, parts, and correct use. Distributed by CET.

From the Document

SERVICE BULLETIN SB-6-133-A Replaces SB-6-133 HAR-508 Regulator Knob Panel Nut Bonnet Maximum Torque 120 in./lbs. Thrust Washer Adjusting Screw As- sembly Main Spring *Slip Ring *Diaphragm Assembly Body Cover *Valve Spring *Valve Assembly Body Assembly Bottom Plug Max. Torque 25 in./lbs. *Bottom Plug O-Ring * KK-5045 Diaphragm Repair Kit DESCRIPTION This unit is designed to regulate and maintain a nearly constant outlet pressure through the front and rear 1/4” NPT ports while passing unregulated air through the 1/2” NPT ports. The front 1/4” port should be fitted with a gauge (such as a DeVilbiss GA-316, sold separately) to verify pressure at the rear 1/4” port. IMPORTANT: Read and follow all Instructions and Safety Precautions before installing, operating or maintaining this equipment. Keep this manual for future reference. Risk of explosion or fire. Improper use can cause personal injury • This product is designed and intended for use in industrial compressed air systems only. Do not use for liquids or gasses other than air. • Do not use where pressure or tem- perature can exceed rated operating conditions (see specifications). • Regulated outlet pressure must nev- er be set higher than the maximum operating pressure of the downstream air tool or equipment. An outlet pres- sure