Binks GEMS Stack Light

Inside This Document

Operating and service manual for the Binks GEMS Stack Light, a GEMS electronic mixing system component — 6 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

#346 #C23 (wire 264) EN 77-3086-R1.0 (8/2015) 4 / 6 Connect the blue/white wire number 264 to location C23 as shown. Tighten the terminal screw to securely anchor the wire. See the GEMS wiring diagram for additional detail. Connect blue wire number 351 into the buzzer terminal labeled X1 (and already containing wire number 341). Find blue wire number 346 at location B05 (visible on the double height terminal blocks just below the control board). Loosen the terminal screw to remove the wire. Install the new blue wire number 346 (part of the stack light assembly) into the board where the previous wire 346 was removed. Install connected wires 346/356 into the double height terminal block location B05 where single wire 346 was removed from. EN 77-3086-R1.0 (8/2015) 5 / 6 Remove the vertical wire tray cover to expose the wiring inside. Route the stack light wires through this tray then replace the cover. Close the enclosure door. Connect electrical power and power on the GEMS system. • The green light is on whenever the AE valve is open. This indicates the system is spraying or ready to spray. • The yellow flashing light will be on whenever there is an alarm. Silencing the alarm will also turn off the yellow light but will not reset the alarm. The HMI main screen will continue to flas