Binks GEMS Solvent Flow Meter Kit

Inside This Document

Operating and service manual for the Binks GEMS Solvent Flow Meter Kit, a GEMS electronic mixing system component — 6 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

#308 #275 EN 77-3089-R1.0 (8/2015) 4 / 6 Open the enclosure door. Remove one of the pre-installed plugs from one three unused strain reliefs. This is where the wire harness will enter the control enclosure. Unscrew the strain relief end nut and feed the flow meter cable through it into the cabinet. Remove the wire tray covers and route the wiring through the wire tray before connecting wiring. The white wire #308 connects into the board terminal location L3C1 (shown below). Tighten the terminal screw so the wire will not slip out once installed. Black wire #275 connects to L3C10 - DCC on the board input. Red wire #216 (#218 if Intrinsically Safe option used) connects to the C13 terminal block. EN 77-3089-R1.0 (8/2015) 5 / 6 Route the cable through both wire trays before placing the covers back in place. With the cable in place, be sure to tighten down the nut end of the strain relief, so the cable cannot be tugged out of position. Verify all connections are solid and tight, and close the enclosure door. Route the cable connector end through the fluid panel opening to the sensor body. Connect the solvent meter connector to the body of the flow sensor and tighten into place. Note the connector and pickup body are keyed so there is only one correct connector orientation. The flow me