Binks GEMS Remote Mix Manifold

Inside This Document

Operating and service manual for the Binks GEMS Remote Mix Manifold, a GEMS electronic mixing system component — 6 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

Remove and replace with 20-2287-1 EN 77-3097-R1.0 (8/2015) 4 / 6 Use a suitable resin hose to connect the mix manifold outlet to the resin inlet of the remote mix block. FOR SINGLE COLOR SETUPS: For easier switching between solvent and paint resin on single color systems use the quick disconnects referenced in the table on page 3. Disconnect the solvent line from the GEMS color stack and use QD bodies on the end of the paint resin and solvent line to connect to a QD stem installed on the resin inlet of the remote mix block. FOR MULTI-COLOR SETUPS: Keep the GEMS color stack plumbed as normal. Color changes and flushes will be performed through the color stack. Installation (cont’d) Remove 3/8” NPS x 1/4” NPT nipple from mix manifold injector valve and plug the injector valve with 1/8” NPT stainless steel plug 20-2287-1. Remove 240-3122-300 or 240-3122-600 static mixer from outlet of mix manifold and connect it to the remote mix block outlet to be used as a mixer / whip hose. For additional whip hose length another hose may be added. Connect the resulting whip hose to the fluid inlet of the spray gun. Operation FOR SINGLE COLOR SYSTEMS: Go to the Settings / Gun 1 Flush/Load Sequence screen and change the Gun 1 Load Volume setting to the new volume established only by the whip hose.