Binks GEMS Operation

Inside This Document

Operating and service manual for the Binks GEMS Operation, a GEMS electronic mixing system component — 62 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN 77-2982-R1.0 (7/2015) 4 / 62 1: Introduction The GEMS system is designed to accurately mix most two component (2K) paints. It will supply any low- pressure manual or automatic spray gun and can easily handle very low flow rates or high ratio materials (greater than 20:1). The system uses real-time metering to accurately dispense and mix the resin and hardener on-ratio regardless of varying flow rate as seen in real world paint applications such as feathering or rapid triggering with manual guns. The system is easily set up and operated with a 7” touch screen. Access to system parameters and usage data is restricted via password protection. GEMS systems are configurable with many options and accessories: • Up to 5 paint colors • Hardener flow sensor • Gun flush boxes • Pedestal Stand • Stack light • Atomizing air cut-off • 2nd gun capability See section 14.0 in this manual for information on accessory equipment. 1.1: Features The GEMS System has unique features that provide superior benefits: Continuous Flow — The mix manifold is designed to optimize mix quality and minimize internal volume by receiving Resin (Component A) and Hardener (Component B) continuously. Accurate Dispensing — Control and positioning of the B metering pump is precise. An electronically controlled steppe