Binks GEMS In Booth Controls

Inside This Document

Operating and service manual for the Binks GEMS In Booth Controls, a GEMS electronic mixing system component — 8 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN 77-3095-R1.0 (8/2015) 4 / 8 Verify the wiring inside the barrier box by referring to the tables below. See the 77-2983 Maintenance & Repair Manual for a wiring diagram and enclosure locations. Installation The remote color change box is designed to be used inside a hazardous environment, such as a spray booth, however, the Zener barrier box must remain with the GEMS control in the non-hazardous area. Mount the barrier box to the GEMS mast as described below. Mount the barrier box to the GEMS mast using the mounting bracket and supplied bolts and nuts, as shown. Installation should be performed by a qualified electrician. Improper installation could create a spark, resulting in fire or explosion. ! WARNING TABLE B—ENCLOSURE WIRING WIRE NUMBER & COLOR ENCLOSURE LOCATION DESCRIPTION 219 RED L2C14 +24v 322 WHITE L3D7 Signal 276 BLACK L2C24 DCC none GREEN ground TABLE A—BARRIER WIRING WIRE NUMBER & COLOR BARRIER TERMINAL (1-8) 219 RED 8 322 WHITE 5 276 BLACK 6 none GREEN GRD foot 4421 RED 1 4441 WHITE 4 DCC BLACK 3 #322 (white - signal) L3D7 7th terminal from right #219 (red - +24V) L2C14 Bottom front terminal on this block #276 (black - DCC) L2C24 Bottom rear terminal on this block EN 77-3095-R1.0 (8/2015) 5 / 8 The barrier box cable (240-3072-3) will connect to the terminals indi