Binks GEMS Gun Add on Kit

Inside This Document

Operating and service manual for the Binks GEMS Gun Add on Kit, a GEMS electronic mixing system component — 6 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

#307 #307 #307 EN 77-3091-R1.0 (8/2015) 4 / 6 Route the wiring through the wire tray and connect the corresponding wire; blue wire #307 connects into the board input terminal location L3B8 (input 7). Tighten the terminal screw so that the wire will not slip out once installed. This is the signal wire to the controller. The other end of the blue wire (ring terminal) should connect to the right stud (as viewed from the inside of the enclosure) on the new switch. Tighten the nut on the stud so the wire will not move. Connect new black wire #211 to the left stud of airflow switch 1 (which has black wire #210 on it) to the left stud of the new airflow switch and tighten the nut so it will not move. This wire provides power to the switch. The second gun must be enabled in the system configuration, accessible only by distributor. Contact distributor for installation and proper kit functionality. Once installed and configured, items like the Air Cut Off kit (see right) or Gun Flush Boxes may be added and used with both guns. EN 77-3091-R1.0 (8/2015) 5 / 6 Power on the system and connect regulated atomizing air to the 1/4” NPS inlet (bottom), and spray gun air hose to the top of the air flow switch. Verify proper operation of the switch by triggering the gun. A green LED on the board (bel