Binks FX30 & FX35 Fluid Section Manual

Inside This Document

The service manual for the Binks FX Series — a fluid pump — 8 pages covering installation, operation, air-motor and lower-end service, seal and packing replacement, and the exploded parts diagrams with replacement part numbers. Binks finishing equipment distributed and supported in North America by CET.

From the Document

77-2955-R5 (1/2018) 1 / 8 www.carlisleft.com SPECIFICATIONS FX30 FX35 Theoretical Output @ 60 cycles/min: 3.0 gpm [11.4 l/m] 3.5 gpm [13.2 l/m] Displacement per cycle: 6.4 oz [190 CC] 7.4 oz [220 CC] Maximum fluid pressure: 7250 psi [500 bar] Maximum operating temperature: 160° F [71° C] Stroke length: 5 in [127 mm] Inlet size: 1 1/4" NPT (f) [Hex] or 1 1/2" NPT (m) [Knock-off] Outlet size: 3/4" NPT (f) Weight: 44.7 lbs [20.3 kg] Wetted parts (Carbon Steel models): Nickel plated Carbon Steel, Stainless Steel, Ceramic coated Stainless Steel, PTFE, UHMWPE Wetted parts (Stainless Steel models): Stainless Steel, Ceramic coated Stainless Steel, PTFE, UHMWPE Carbon Steel Models: FX30PU-CAK (PTFE/UHMW) FX35PU-CAK (PTFE/UHMW) Stainless Steel Models: FX35PU-SAK (PTFE/UHMW) FX35PU-SAH (PTFE/UHMW) FX30 & FX35 FLUID PUMP ASSEMBLIES EN SERVICE MANUAL 77-2955-R5 (1/2018) 2 / 8 EN www.carlisleft.com Binks reserves the right to modify equipment specification without prior notice. DE-ENERGIZE, DEPRESSURIZE, DISCONNECT AND LOCK OUT ALL POWER SOURCES DURING MAINTENANCE Failure to De-energize, disconnect and lock out all power supplies before performing equipment maintenance could cause serious injury or death. OPERATOR TRAINING All personnel must be trained before operating finishing equipment. EQUIPMENT MISUSE HAZARD Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and result in serious injury. PROJECTILE HAZARD You may be injured by venting liquids or gases that are released under pressure, or flying debris. PINCH POINT HAZARD Moving parts can crush…