Binks Dad-500

Inside This Document

Operating and service manual for the Binks Dad-500, a spray-finishing accessory — 8 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

Part No. Description Qty. Supplied DAD-1 Desiccant 1 HAF-6 Water Separater Filter Element and O-Ring 1 DAD-8 In-Tank Filters Replacement Instruc - tions (for filter between the coalescing filter (stage 2) and the desiccant tank air inlet (stage 3). These filters keep the desiccant within the tank : Replacing the air filter is not normally needed. It is required only when the filter has been damaged or plugged because the unit was not properly maintained. 10. Be sure air supply to unit is shut off and bleed off all air pressure from the DAD unit. 11. Make sure the desiccant material is drained from unit per above instructions. 12. Remove the air supply line from the water separator inlet (first stage). 13. Remove the filter bowls and filter elements from both the first and second stage filters of the unit. 14. Use an open end 7/8" wrench and remove the hex nipple between the DAD tank and the coalescing filter. The nipple should unscrew out of the tank. 15. Using a large #3 Phillips screwdriver, un - screw the filter. 16. Use a large #3 Phillips screwdriver and reverse the above procedures to install a new DAD-8 filter. Install about halfway into the tank fitting. 17. Reverse procedure to reassemble. Refill with desiccant. DAD-8 In-Tank Filter Replacement Instruc - tions (for the f