Binks Air Motor Drives and Agitators for Pressure Tanks

Inside This Document

Operating and service manual for the Binks Air Motor Drives and Agitators for Pressure Tanks, a paint pressure feed tank — 72 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN 77-3110-R1.3 (4/2016) 4 / 14 AIR SUPPLY Air supplies (compressors etc.) shall be sited in a non- hazardous area with a filter on the air intake system to prevent the ingress of dust or similar foreign materials into the parts where compression takes place. Before attempting any installation of agitators onto pressure feed tanks, the tanks must be relieved of pressure as high pressure can cause a serious injury. Pressure is maintained in a pressure tank after the system has been shut down. Before attempting removal of cover, fill cap, or center plug, pressure must be relieved using the following steps: ! WARNING PRESSURE RELIEF PROCEDURE 1. Turn off the main air supply to the tank. 2. Close air inlet valve located on tank air manifold. Remove air inlet hose. 3. Bleed off air in the tank by turning the air relief valve thumb screw counter-clockwise. Wait until all the air has escaped through the valve before removing the pressure tank cover, fill cap, or center plug. 4. Leave the air relief valve open until you have reinstalled the cover, fill cap, or center plug. AIR MOTOR LUBRICATION (ALL MODELS) An automatic air line filter/lubricator should be installed in the air supply line no more than 0.5m from the air motor. The filter should be 5 micron. Install the lubricator level wi