Binks Agitator Assembly Kits

Inside This Document

Operating and service manual for the Binks Agitator Assembly Kits, a paint agitator / air-motor drive — 8 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

EN SBBI-19-046-G ( 4 /2016) 4 / 8 7 10. Place agitator shaft (23) with paddle (26) into bottom of shaft coupling (21) and tighten bottom set screw (22). Use Loctite 242 (blue) on threads of set screw. Refer to SBBI-19-087 for installation of the motor to be used. OPERATION Once the agitator assembly is installed with an air motor, its operation is controlled by the motor. Refer to the specific service instruction for the type of motor installed. Ref. Replacement Individual No. Part No. Description Parts Req. 1 QMS-46 Retaining Nut 1 2 QMS-447 Thrust Collar Kit 1 (Includes 3 and 4) 3 --- Thrust Collar 1 4 --- Set Screw 1 (5/16-18 x 3/8) 5 KK-5049 Thrust Washer Kit 2 6 QMS-407 Bearing Assembly - S.S. 1 QMG-409 Bearing Assembly - Galv. 1 7 SSG-8184-K2 O-Ring (Kit of 2) 1 8 KK-5042 Shaft Seal Kit 1 8A --- Shaft Seal 1 8B --- Retainer 1 9 QMS-5 Agitator Shaft S.S. 1 for 2 Gallon. QMS-6 Agitator Shaft S.S. 1 for 5 Gallon QMS-7 Agitator Shaft S.S. 1 for 10 Gallon QMS-8 Agitator Shaft S.S. 1 for 15 Gallon 10 QMS-449 Agitator Paddle Kit 1 2 Gallon (Includes 11 and 12) 11 QMS-444 Agitator Paddle Kit 1 5 Gallon (Includes 11 and 12) 12 --- Hex Socket Head Cap 1 Screw (5/16-18 x 1-1/4) S.S., Purchase locally Parts List for Gear Driven Agitator Assemblies 1 2 3 4 5 Figure 2 - Gear Driven Agita