Binks 55 Gallon Gear Driven Drum Cover Agitators

Inside This Document

Operating and service manual for the Binks 55 Gallon Gear Driven Drum Cover Agitators, a paint pressure feed tank — 8 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

4 AIR MOTOR DRIVE SERVICE CHECKS OPERATION AND MAINTENANCE CONDITION CAUSE CORRECTION 1. Air motor needs lubrication or cleaning. 2. Motor vanes need replacing or contaminants present in motor chamber, Figure 2. 3. Low oil level in gear box, Figure 3. 4. Gear and shaft assembly (58) and/ or worm gear (65) worn, Figure 3. 5. Air motor bearing (40 or 51) worn, Figure 2. Air motor sluggish or inefficient Oil leakage from gear box. 1. Seal (62, Figure 3) worn. 1. Lubricate (see "Air Motor Lubrication" section). Disassemble and clean per parts replacement instructions. 2. Disassemble, clean motor per parts replace- ment instructions. Replace worn vanes. 3. Add oil per lubrication instructions. 4. Replace worn parts per parts replacement instructions. 5. Replace bearings per parts replacement instructions. 1. Replace seal per parts replacement instructions. Always install new gaskets (45) when reassembling air motor. Assemble the end plates to the body using an arbor press with a pusher acting on both races of the bearing while rigidly supporting the opposite (drive) end of the shaft. Gear Box (refer fo figure 3, page 7) 1. Remove oil fill plug (60) or cover plate (56) and drain gear box lubricant. 2. Remove set screws (63) and remove gear box from air motor. 3. Disassembly gear box pe