C.A. Technologies MiniCAT 60-650

Inside This Document

The setup and parts sheet for the C.A. Technologies MiniCAT (60-650) — CAT's compact touch-up gun. The air cap and fluid nozzle chart covers the 0.6–1.8 mm fluid tip range with available nozzles from 0.6 mm (31-0606) through 0.7, 1.0, 1.2, 1.3, and 1.5 mm with matching needles. The 5-page reference for setting up and servicing the small-format gun on touch-up, detail, and small-part work.

From the Document

MINICAT AIR CAP AND FLUID NOZZLE CHART MODEL NO. PRESS / SIPHON AIR CAP FLUID TIP RANGE FAN CONTROL AVAILABLE FLUID NOZZLES NEEDLES 0.6 - 1.8 31-0606 0.6mm (.022") 0.6 - 1.8 31-0607 0.7mm (.028") 0.6 - 1.8 31-0610 1.0mm (.040") 0.6 - 1.8 31-0612 1.2mm (.046") 0.6 - 1.8 31-0613 1.3mm (.052") 0.6 - 1.8 31-0615 1.5mm (.059") 0.6 - 1.8 31-0618 1.8mm (.070") *Gun inlet pressures may vary as required by application MINICAT None Pressure / Siphon 40-1115 21-M66 AIR CAP RING 21-203 40-M110 40-M407 MINI AUTOMATIC SPRAY GUN PRODUCT INFORMATION MiniC MiniC MiniC MiniC MiniCA A A A AT 60-650 T 60-650 T 60-650 T 60-650 T 60-650 Operation and Maintenance Instructions for MiniC MiniC MiniC MiniC MiniCA A A A AT T T T T Spray Guns Operation 1. Connect air supply hose at handle of gun. 2. Connect a pressurized fluid supply or paint siphon supply to the gun fluid inlet. Maintenance IMPORTANT! Routine cleaning and maintenance is essential to insure proper gun operation. Several states prohibit spraying solvent into the atmosphere and require the use of covered gun cleaner. 1. If a gun cleaner is being used, connect and clean the gun in the gun cleaner according to the manufactures instructions. 2. If a gun cleaner is not being used: Remove air cap and clean separately using clean solvent. For pressure setups, connect a pressurized solvent supply to the fluid inlet, trigger the gun allowing solvent to flow thru the gun until clean. For siphon setups, first clean the siphon supply container thoroughly then spray clean solvent thru the gun until clean. NOTE: Gun head disassembly is not…