Binks Pogo Pump Manual

Inside This Document

The service manual for the Binks Pogo — a fluid pump — 24 pages covering installation, operation, air-motor and lower-end service, seal and packing replacement, and the exploded parts diagrams with replacement part numbers. Binks finishing equipment distributed and supported in North America by CET.

From the Document

EN 77-3040-R1.2 (10/2014) 1 / 12 SERVICE MANUAL PX1304 POGO PUMP ASSEMBLIES SPECIFICATIONS PX1304-5 PX1304-8 Ratio: 4:1 Maximum air inlet pressure: 72.5 psi [5 bar] 116 psi [8 bar] Maximum fluid pressure: 290 psi [20 bar] 500 psi [34.5 bar] Displacement per cycle: 2.7 oz [81 CC] Theoretical Output @ 60 cycles/min: 1.3 gpm [4.9 l/m] Maximum recommended continuous cycle rate: 20 cycles/min. [40 strokes] Maximum recommended intermittent cycle rate: 40 cycles/min. [60 strokes] Maximum operating temperature: 160°F [71° C] Piston diameter: 3.3 in (85 mm) Nominal motor stroke: 3 in [75 mm] Air inlet connection: 3/8" NPS / BSPP (female) Outlet size: 1/2" NPT (female) Weight: 12.6 Lb [5.7 Kg] EN 77-3040-R1.2 (10/2014) 2 / 12 Binks reserves the right to modify equipment specification without prior notice. In this part sheet, the words WARNING , CAUTION and NOTE are used to emphasize important safety information as follows: Hazards or unsafe practices which could result in minor personal injury, product or property damage. ! CAUTION Hazards or unsafe practices which could result in severe personal injury, death or substantial property damage. ! WARNING Important installation, operation or maintenance information. NOTE Read the following warnings before using this equipment. IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PROVIDE THIS INFORMATION TO THE OPERATOR OF THE EQUIPMENT. FOR FURTHER SAFETY INFORMATION REGARDING THIS EQUIPMENT, SEE THE GENERAL EQUIPMENT SAFETY BOOKLET (77-5300). ! WARNING DE-ENERGIZE, DEPRESSURIZE, DISCONNECT AND LOCK OUT ALL POWER SOURCES DURING MAINTENANCE…