Binks MX3042 & MX3536 Pump Assemblies

Inside This Document

Operating and service manual for the Binks MX3042 & MX3536 Pump Assemblies, a medium-/high-pressure piston pump outfit — 16 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

77-2963-R2 (1/2018) 4 / 16 EN www.carlisleft.com HAZARD CAUSE SAFEGUARDS EXPLOSION STATIC ELECTRICITY Use of this equipment in a potentially explosive atmosphere. Vapors from flammable liquids can catch fire or explode from static electricity discharges. 1. If installing this equipment in a potentially explosive atmosphere, check the ATEX equipment category and temperature ratings meet the requirements for the zoned area. 2. Check electrical continuity of the air supply to earth — should be no greater than 10 6  . 3. Electrically bond all metallic equipment to earth. Should be no greater than 1  . SPECIAL CONDITIONS FOR SAFE USE REQUIRED BY ATEX CERTIFICATION Over pressurization of equipment can cause equipment failure or injury. Use lubricating medium resistant to carburisation. Improper operation or maintenance may create a hazard. 1. Do not exceed the stated maximum working pressures and motor speed as specified in this manual. 2. Only a suitably approved static dissipating or conductive air supply hoses shall be attached to the equipment and terminated to the air supply. 3. Air supplies (compressors, etc.) shall be sited in a non- hazardous area with a filter on the air intake system to prevent the ingress of dust or similar foreign material into the parts where compression