Binks Maple 8-25 Pump Manual

Inside This Document

The service manual for the Binks Maple — a fluid pump — 16 pages covering installation, operation, air-motor and lower-end service, seal and packing replacement, and the exploded parts diagrams with replacement part numbers. Binks finishing equipment distributed and supported in North America by CET.

From the Document

Instruction Manual Maple 8/25 Pump Model 10 40 42 Instruction Manual Page 2 of 16 77-3232-R2.0 Instruction Manual Page 3 of 16 77-3232-R2.0 Specification Pump Ratio 25:1 Max. Air Pressure Inlet 7 Bar Max. Fluid Pressure 175 Bar Nominal Flow Volume / Cycle 0.2 Litres 0.053 US Gall Fluid Output @ 60 cycles/min 12 Litres / min 3.2 US Gall / min Maximum Recommended Continuous Cycle Rate Maximum Recommended Intermittent Cycle Rate 20 Cycles /min 40 Cycles /min Fluid Connections Inlet Outlet 1” Sanitary ½” NPT Female Compressed Air Inlet 1/2” BSPP / NPSM Air Volume / cycle 0.7 SCFM (9.5 L/m) @ 45PSI (3.1 Bar) 1.4 SCFM (18.5 L/m) @ 90 PSI (6.2 Bar) Air Flow @ 15 cycles/min 6 bar Air Flow @ 30 cycles/min 6 bar 21 CFM (595 L/min) 42 CFM (1190 L/min) Max. Pump Inlet Pressure 2 Bar (30 PSI) Air Quality ISO 8573.1 Class 3.3.2 # (See Note) Dirt 5 microns Water -20ºC@7bar (940ppm) Oil 0.1mg/m³ Total Weight of Pump 40 Kg / 88 lbs # Note: Class 3.4.2 Air Quality (Refrigerant dried - water + 3ºC@7bar) may be used, however, above 15 cycles/min optional piped exhaust system should be used, if used continuously. Instruction Manual Page 4 of 16 77-3232-R2.0 Instruction Manual Page 5 of 16 77-3232-R2.0 Instruction Manual Page 6 of 16 77-3232-R2.0 KEY = GREASE (AGMD-010) = LOCTITE = TORQUE = GREASE INTERNAL (AGMD-010) = MAINTENANCE ORDER (REVERSE FOR ASSY) ITEM 4 DETAIL Instruction Manual Page 7 of 16 77-3232-R2.0 Parts List – 104042 ITEM PART No DESCRIPTION QTY REMARKS 1 0115-010037 POPPET ASSEMBLY 2 # 2 161993 Ø20.35 x 1.78 O’RING 2
3 161994 Ø4.47 x 1.78 O'RING 4
4 162729 SHAFT SEAL 2
5…