Binks Maple 30 Pump Manual

Inside This Document

The service manual for the Binks Maple — a fluid pump — 28 pages covering installation, operation, air-motor and lower-end service, seal and packing replacement, and the exploded parts diagrams with replacement part numbers. Binks finishing equipment distributed and supported in North America by CET.

From the Document

Instruction Manual For Maple 30 - Pump Model 104010 Instruction Manual Page 2 of 28 77-3235-R3.0 Instruction Manual Page 3 of 28 77-3235-R3.0 Index Section 1.1 General Description 1.2 Operating Principle 1.3 Specifications 1.4 Dimensions and Mounting Details 2.1 Important Safety Information 3.1 Installation - General 4.1 Parts Lists Main Pump 4.2 Parts Lists Air Motor 4.3 Parts Lists Fluid Section 4.4 Parts Lists Reference 5.1 Maintenance – Air Motor Assembly Procedure 5.2 Maintenance – Fluid Section Assembly 5.3 Maintenance – Final Pump Assembly 6.1 Maintenance - General 6.2 Maintenance - Fault Finding 7.1 Spare Parts Lists 7.2 Accessories Instruction Manual Page 4 of 28 77-3235-R3.0 General Description – Section 1.1 High Quality materials and surface treatments are used in the construction of this pump to ensure both extended operational life and good future appearance. The Maple pump is a horizontal piston pump for pumping Solvent / Waterborne Paints, Solvents and other suitable materials. An Ø180 x 50mm stroke air motor is used to drive two fluid sections giving a combined output of 0.75 L per cycle. The unit combines an energy efficient air motor with low shear fluid section technology from the range of Smart Electric Pumps. The Maple Pump achieves a reciprocating drive by using high technology ground and lapped steel spool and sleeve air valves to control the air motor reversal, providing reciprocating motion. The air valve design (patent pending) ensures a positive magnetic detent for the main and pilot air valves thus removing the possibility for a stall condition.…