Binks High Pressure Regulator

Inside This Document

Operating and service manual for the Binks High Pressure Regulator, an electric-drive high-pressure pump system — 20 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

Instruction Manual 77-3315 Page 4 of 20 Issue: 3.3 General Description – Section 1.1 The Binks range of high pressure regulators and back pressure regulators give complete control for viscous and heavy materials. They are suitable for use with all solvent and waterbased paints, mastics and sealers. All wetted parts are stainless steel with PTFE seals and tungsten carbide seats. The rugged construction gives long maintenance free life. The units have high flow characteristic by incorporation of large flow regulating orifice with 3/4" NPT connection ports, this enables use for systems or single operator ‘take offs’. The Tungsten carbide seats allow for long maintenance free operation, unique shaft seal design incorporating a ‘wiper lip’ preventing ingress of material filler particles into the sealing area reducing shaft and seal wear. The PTFE shaft seal is impregnated for increased life. The Simple construction gives ease of maintenance and installation. Fluid Regulators and Back pressure regulators are available as air pilot operated versions, which prevents the need for large spanners when changing required pressures. Instruction Manual 77-3315 Page 5 of 20 Issue: 3.3 Operation – Section 1.2 Regulator The regulator will maintain the pressure of a fluid at the outlet port to that