Binks Gemini 41-818830 Manual

Inside This Document

The service manual for the Binks Gemini — a fluid pump — 18 pages covering installation, operation, air-motor and lower-end service, seal and packing replacement, and the exploded parts diagrams with replacement part numbers. Binks finishing equipment distributed and supported in North America by CET.

From the Document

Model 41-818830 Quality System ISO9001 Certified Environmental Management System ISO14001 Certified Certified Quality ION PORT T (INTERNAL) (EXTERNAL) 5.50 140 4X .38 10 ST PORT 1.42 36 5.60 142 1.75 44 SUCTION PORT (OPTIO 1/2" NPT (INTERNAL) Binks 195 International Blvd., Glendale Heights, IL 60139 USA Telephone: 1.800.99.BINKS 630.237.5000 Toll Free Customer Service and Technical Support 800-992-4657 Toll Free Fax 888-246-5732 Part Sheet 77-2997 1: PUMP SPECS 2: INSTAL & OP 3: EXP VIEW 4: AIR END 5: WET END 6: CERTIFICATES SERVICE & OPERATING MANUAL Original Instructions 41-818830sm-rev0812 IMPORTANT Read the safety warnings and instructions in this manual before pump installation and start-up. Failure to comply with the recommendations stated in this manual could damage the pump and void factory warranty. When used for toxic or aggressive fluids, the pump should always be flushed clean prior to disassembly. Airborne particles and loud noise hazards. Wear eye and ear protection. Before maintenance or repair, shut off the compressed air line, bleed the pressure, and disconnect the air line from the pump. Be certain that approved eye protection and protective clothing are worn at all times. Failure to follow these recommendations may result in serious injury or death. To be fully groundable, the pumps must be ATEX Compliant. Refer to the nomenclature page for ordering information. Optional Ground Strap (0114-014178) is available for easy ground connection. To reduce the risk of static electrical sparking, this pump must be grounded. Check the local electrical code for…