Binks E2-60 Electric Drive

Inside This Document

Operating and service manual for the Binks E2-60 Electric Drive, an electric-drive fluid pump — 28 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

Instruction Manual Page 4 of 28 77-3228-R1.2 Instruction Manual Page 5 of 28 77-3228-R1.2 Instruction Manual Page 6 of 28 77-3228-R1.2 Installation – General The E2-60 Pump Units are designed for location in Zone 1 Hazardous areas, ATEX Category 2. Electrical connections must be in accordance with Local regulations for installation in Hazardous areas. The E2-60 Pump Unit must be flushed with a compatible flushing solvent or equivalent before use. It is recommended that a Local Control Box is positioned in close proximity to the pump, as a convenient local Start / Stop facility and Junction box. The main Pump Control Panel must be positioned within an Electrically Safe Area. A Pressure switch (and/or Pressure relief valve) must be connected to the outlet manifold port and set to stop the pump (or relieve the fluid pressure) in the event of the system overpressure e.g. blocked paint filter. This is necessary to protect the Pump mechanics from overload. An adapter to mount a pressure switch and pressure sensor is available, see accessories. It is recommended that the switch setting is set to 1 bar (14.5 psi) above the maximum required pressure. The maximum Pressure setting the pressure switch should be set to is 21 bar (305 psi). The pressure switch must be fitted and functioning co