Binks 77-3235 Maple 30

Inside This Document

Operating and service manual for the Binks 77-3235 Maple 30, a Maple piston fluid pump — 28 pages. Covers correct use, safety, setup, operation, maintenance, and the spare-parts breakdown for service. Distributed by CET.

From the Document

Instruction Manual Page 4 of 28 77-3235-R3.0 General Description – Section 1.1 High Quality materials and surface treatments are used in the construction of this pump to ensure both extended operational life and good future appearance. The Maple pump is a horizontal piston pump for pumping Solvent / Waterborne Paints, Solvents and other suitable materials. An Ø180 x 50mm stroke air motor is used to drive two fluid sections giving a combined output of 0.75 L per cycle. The unit combines an energy efficient air motor with low shear fluid section technology from the range of Smart Electric Pumps. The Maple Pump achieves a reciprocating drive by using high technology ground and lapped steel spool and sleeve air valves to control the air motor reversal, providing reciprocating motion. The air valve design (patent pending) ensures a positive magnetic detent for the main and pilot air valves thus removing the possibility for a stall condition. The air motor also utilises the Binks Low Ice quick exhaust technology to prevent air valve freezing conditions when high cycle speeds are employed. Equal thrust on each stroke due to the horizontal configuration incorporating the dual piston rod design gives a balanced fluid pressure output and reduces fluid pressure fluctuations to a minimum. Th