Wagner Sprint X EPG Controller Manual

Inside This Document

The service manual for the Wagner Sprint X — a equipment — 104 pages covering setup, operation, maintenance, and the parts list. Wagner finishing equipment distributed and supported in North America by CET.

From the Document

0102 II 3(2)D IP64 80 °C P_01742 EPG SPRINT X 2x 2x 0 % 100 % kV 80 60 40 20 100 Tri Cor 5 4 3 2 1 120 80 40 20 10 10 20 30 40 50 60 70 80 90 Ø 12 10 11 9 8 m /h 2.0 3.0 0.5 0.3 0.1 1.5 3 5.5 4.5 3.5 2.5 Tri μA Universal Control Unit for Powder Guns EPG-SPRINT X Version 06 / 2014 Translation of the Original Operating Manual 3 EPG-SPRINT X OPERATING MANUAL VERSION 06/2014 ORDER NUMBER DOC2329371 Table of Contents 1 GENERAL INFORMATION 6 1.1 Preface 6 1.2 Warnings, Notices, and Symbols in this Operating Manual 6 1.3 Languages 7 1.4 Abbreviations 7 2 CORRECT USE 8 2.1 Device Type 8 2.2 Type of Use 8 2.3 Use in Potentially Explosive Areas 8 2.4 Safety Parameters 9 2.5 Reasonably Foreseeable Misuse 9 2.6 Residual Risks 10 3 IDENTIFICATION 11 3.1 Explosion Protection Identification in Accordance with ATEX 11 3.2 Permissible Device Combinations 11 4 GENERAL SAFETY INSTRUCTIONS 12 4.1 Safety Instructions for the Operator 12 4.1.1 Electrical Devices and Equipment 12 4.1.2 Staff Qualifications 12 4.1.3 Safe Work Environment 12 4.2 Safety Instructions for Staff 13 4.2.1 Safe Handling of WAGNER Powder Spray Devices 13 4.2.2 Grounding the Device 13 4.2.3 Product Hoses 13 4.2.4 Cleaning 14 4.2.5 Handling Powder Lacquers 14 4.3 Protective and Monitoring Equipment 15 4.4 Safety Feature Identification 16 5 DESCRIPTION 17 5.1 Areas of Application 17 5.2 Technical Data 18 5.3 Permitted Accessories 20 5.4 Scope of Delivery 20 5.5 Operating Elements 21 5.5.1 Operating Elements Front Side 21 5.5.2 Connections on the Rear Side of the EPG-SPRINT X 26 6 ASSEMBLY AND COMMISSIONING 28 6.1 Training…