Sagola Classic Pro XD (Gravity) Manual

Inside This Document

Owner's manual for the gravity-feed Classic Pro XD, an updated version of Sagola's Classic Pro gun. Covers setup, air cap and needle/nozzle combinations, spraying, cleaning, and the full parts breakdown.

From the Document

Mix, prepare and filter the product to be applied in accordance with the manufacturer’s instructions, ensuring that any foreign bodies are prevented from spoiling the quality of finish and application. Should there be any doubt relating to the purity of the product, its composition, etc., please contact your supplier. Useful tips 07.1.- General advice You are recommended to use the gun with the product regulator open (without removing it completely from its housing) in order to minimise wear to the fluid tip and needle and to ensure maximum amplitude. Use the lowest spray pressure in the nozzle that allows you to obtain the required finish. Not all products require the maximum pressure for correct spraying. With a lower pressure, less air is consumed and there is an additional increase in product transfer. The gun leaves the factory ready to spray products correctly with the air nozzle corresponding to each application. It is adjusted to an air inlet pressure of 2 bar to ensure maximum performance. The thickness of the film deposited may be greater than planned if the application spe