Sagola 4600 Series (incl. Digital) Manual

Inside This Document

The complete manual for Sagola's flagship 4600 series — the gun built around DFT (Dynamic Flow Technology), which draws ambient air surrounding the air cap into the spray pattern for flawless finishes at lower working pressures, with enhanced fan stability and reduced overspray. Documents the BASE, HVLP, CLEAR, and CLEAR PRO configurations plus the 4600 Digital, whose interchangeable caps and needles enable up to 20 setups from a single gun body. Includes setup, the digital pressure display, maintenance, and the full parts breakdown.

From the Document

Should there be any doubt relating to the purity of the product, its composition, etc., please contact your supplier. Useful tips 07.1.- General advice You are recommended to use the gun with the product regulator open (without removing it completely from its housing) in order to minimise wear to the fluid tip and needle and to ensure maximum amplitude. Use the lowest spray pressure in the nozzle that allows you to obtain the required finish. Not all products require the maximum pressure for correct spraying. With a lower pressure, less air is consumed and there is an additional increase in product transfer. The gun leaves the factory ready to spray products correctly with the air nozzle corresponding to each application. It is adjusted to an air inlet pressure of 2 bar to ensure maximum performance. The thickness of the film deposited may be greater than planned if the application speed is low, and the opposite is also true.. If the thickness of the layer is very thin , this is due to the fact that the air pressure is excessive for the amount of product being applied. Reduce the air