DeVilbiss TGS-503 Cup

Inside This Document

The product brochure for the DeVilbiss TGS-503 accessory — 2 pages covering its features, specifications, and configuration options. DeVilbiss finishing equipment distributed and supported in North America by CET.

From the Document

SB-4-090-R1 (10/2018) 1 / 2 www.carlisleft.com DESCRIPTION The TGS-503 8 ounce polyethylene cup is typically used in the applica - tion of small amounts of material as in touch-up work. The TGS-503 is suitable for use with all common paints and solvents. Note TGS-503 cup can be used with chlorinated solvents. These solvents will not affect the material used in this cup. Refer to NFPA-33 publication regarding proper storage of flammable/combustible materials. INSTALLATION Fasten cup to gun by attaching to fluid inlet nipple on gun body. Tighten only until snug. Lid Assembly (2) should be positioned so vent hole is to rear. When spraying upwards, it may be necessary to position vent toward front of gun body. OPERATION Strain all materials prior to putting into cup (5). A 90 mesh screen is recommended for this purpose. Do not fill cup (5) beyond level shown. See Figure 1. PREVENTIVE MAINTENANCE Clean with solvent and wipe with rag. This lid assembly can be used along with AD-404 (1) adapter for use with JGA, MBC or other guns with a 3/8" NPS(M) fluid inlet. The EGA gun uses this lid assembly without the adapter. One C-422 (6) cup lid is included. Not a purchasable part. Included in TGS-406 (5). Replacement Individual Part No. Description Parts. Req. 1 AD-404 Adapter - Accessory 1 1/4" NPS(M) x 3/8" NPS(F) 2 TGS-401 Lid Assembly 1 3 TGS-4-K5 Gasket (Kit of 5) 1 4 TGS-6-K5 Fluid Tube 4" (Kit of 5) 1 5 TGS-406 Cup and Cover Assembly 1 (Polyethylene) 6 Cup Lid 1 Ref. No . Figure 1 3 2 Keep vent hole open Do not fill above 250 ml line 1/4 NPS (F) 6 4 5 1 IMPORTANT! DO NOT DESTROY…