C.A. Technologies 2.5 Gallon Stainless Steel Pressure Tanks

Inside This Document

The product information manual for C.A. Technologies' 2.5 gallon stainless steel (non-ASME) pressure tanks: 51-801 single regulated and 51-802 double regulated. Stainless construction suits waterborne and catalyzed coatings; the manual covers operation, safety, and the complete stainless parts breakdown.

From the Document

2.5 GALLON SS (NON-ASME) 51-801 SINGLE REGULATED 51-802 DOUBLE REGULATED STAINLESS STEEL NON AGITATED PRESSURE TANK PRODUCT INFORMATION Coating Atomization Technologies 337 South Arthur Avenue, Louisville CO 80027 Phone: 888.820.4498, Fax: 303.438.5708 www.spraycat.com IMPORTANT NOTE: IF THIS PRESSURE TANK IS TO BE USED FOR SPRAYING FLAMMABLE MATERIALS, OPERATOR MUST NOT PRESSURIZE THIS TANK MORE THAN 15 PSI TO MEET OSHA REQUIREMENTS. FOR NON-ASME PRESSURE VESSELS. IT IS THE RESPONSIBILITY OF THE OPERATOR TO FOLLOW THIS MANDATORY PROCEDURE. GENERAL INFORMATION This pressure tank is equipped with either single or double air pressure regulation, pressure safety relief valve, tank vent valve, a disposable plastic liner, and four caster wheels. CAUTION! 1. Maximum tank pressure of 80 psi. The safety relief valve is designed to protect the tank against excessive pressures. DO NOT attempt to make adjustments to this valve. If this valve begins to vent air, reduce the setting on the air inlet regulator. 2. DO NOT alter the tank in any way by welding, drilling or machining as this may weaken the structure of the tank. 3. To prevent hazardous static sparks from occurring, always ground the tank by connecting a 12 ga. wire to the tank and to a known earth ground. 4. Halogenated solvents will react chemically with aluminum and may cause an explosion. Examples of halogenated solvents are 111 trichlorethane and methylene chloride. DO NOT use the removable aluminum tank liner with any halogenated solvents. 5. Be sure tank pressure is completely relieved before attempting to remove tank…